HP 1820-48G 設定TRUNK (LACP)

hpHP 1820-48G 設定Trunk (LACP)筆記:


 

  1. Trunks -> Configuration,將要作為Trunk (LACP)的port設定至特定Trunk,如port 48、49設至TRK1,Type改Dynamic。
  2. VLAN -> Configuration,新增VLAN ID。
  3. VLAN -> Port Membership,選擇VLAN ID,在Interface找到TRK1,將VLAN ID設為Tagged,重複此動作,將要設定至Trunk (LACP)的VLAN全數加入(VLAN 1設tagged或Untagged皆可作用)。

 

Tips.

  • 若只有單port要做Trunk,可以省略步驟1.,另在步驟3.的Interface由TRK1改成設定該Port即可。

Leave a Comment

Please note: Comment moderation is enabled and may delay your comment. There is no need to resubmit your comment.